I’ve been saving up for a new bed for months, but I still don’t know how to make one that looks like this.
I’m sure I’ll figure it out someday, but until then, here are my steps to make something cute and functional.
I use two fabric blocks, so you’ll need two different colors.
First, cut them in half lengthwise and cut out the corners.
Then cut two pieces of fabric with the side edges going through the center of the fabric block.
Then, fold the top half over, making sure it’s centered at the bottom.
Then fold the bottom half over again, making the corner a little bit more rounded.
Next, cut a piece of fabric for each side of the bed cover.
Cut out the sides of the pillow cover to the size you want.
Use the leftover fabric to create the pillow, and then add two fabric squares to each side.
Then, using a sewing machine, sew the two pieces together.
Cut out the pillow and put it on the pillow block, and trim the excess fabric.
Then use a small needle to pull the edges of the foam to fit over the pillow.
You should end up with a pretty comfortable pillow, though you can also make a simple bed cover if you want a more decorative look.
This is an easy bed cover that’s super cute and useful for people who are in the middle of a long project, like I was.
If you don’t want to go that DIY route, you can use a few different materials for the pillow instead of the block.
A piece of paper towel.
The fabric block I’m using for the foam is very easy to cut.
I used a large, long piece of thin cardboard, and it worked great.
A few squares of paper.
I love using this paper towel because it is thick enough to be used for the backing, which will help to hold the foam in place.
For this pillow, I made sure to use a ruler to measure out the foam and place the foam squares in the center.
A glue gun.
When you cut the foam square, make sure you mark off the corners to make sure that you don�t cut the sides.
A little tape.
To make the foam look a little less like a bed, I glued some foam to each of the squares, but you can do this by simply adding more foam onto the foam, or you can make it a little sticky by adding a bit of glue.
A bit of scissors.
Sometimes, you just don’t have the time to use the scissors, but for this project, I found that a small cutting tool would be ideal.